Cat walk build for Toro Pro Pass 200

Nice little addition . This cat walk was easy to build and will save the rear fenders from getting bent and guys hanging of the side trying to clear/clean or check hopper . 

material used 1.5"x2.5" - 1/8" tube stock cut  3 lengths at 20".Slide them in position and mark holes for pins after you get it set up in the next step . 

   

I'm using 1.5 " -1/8" angle for rails 2 x 56" . Mark just the inside one so you can flip it over to weld . Outside piece weld in place over hanging tube stock . Line up cat walk so it is just inside fender . Mark the holes for pins now .  

Clamp and ready to tack weld . 

Made a simple step with stock left over. 

Disconnect battery before welding !

After tack weld ,remove and weld up joints . Step was around 8" riser .

 Remove and flip over to measure for mesh top .

Went with 1/2" mesh to let the sand go through and better foot traction .

Already 

Test fit for the last time . Goes on easily.

Cleaning it up for 

Primer and

Paint.

And done .